



![]()
IGET Bar Plus S3 Device Body
The IGET Bar Plus S3 device is the reusable half of the system. It carries the 950mAh battery, the USB Type-C port and the small screen that reports charge, while the pod supplies the e-liquid and coil. Buy the body once, then replace only the pod.
What is in the box
The box holds the device body in the finish you choose, a short charging cable and the usual paperwork. There is no pod inside, so add at least one BAR PLUS S3 pod before the first session. The body also accepts the earlier BAR PLUS 6,000 puff pod.
Five finishes are stocked: Mystic Gunmetal, Tidal Gunmetal, Light Purple, Carbon Gray and Rose Pink. The finish is cosmetic. Battery, display and pod slot are identical across all five.
Battery, charging and the status screen
The 950mAh cell charges over USB Type-C at 5V/1A and reaches full in roughly 60 to 90 minutes. The display shows how much charge is left, which removes the guessing that comes with a sealed disposable.
Top up at 20 to 30 percent instead of running the cell to zero. A shallow charge takes the same time, is gentler on the battery and keeps the body ready whenever you want a draw.
IGET Bar Plus S3 pod specifications
| Specification | IGET factory data |
|---|---|
| Brand | IGET |
| Series | BAR PLUS S3 |
| Product type | Rechargeable device body |
| Battery | 950mAh |
| Charging | USB Type-C |
| Display | Smart battery status screen |
| Dimensions | Φ30.5 × 126.9 mm |
| Weight | 100.6 g |
| Materials | PCTG, PC, stainless steel |
| Pod included | No — sold separately |
| Compatible | S3 pod (10,000 puffs) & BAR PLUS pod (6,000 puffs) |
A pod system instead of a sealed disposable
The BAR PLUS S3 separates the consumable from the hardware. E-liquid and mesh sit in the pod; the battery, charging port and display stay in the body. Only the part that actually wears out gets replaced, which is why the running cost per puff is lower than a sealed device.
There is a practical side too. Because the body is rechargeable and the pod is swappable, you can carry one device and two flavours instead of two complete disposables.
From box to first puff
Charge the body, uncap the pod, and press it into the slot until it seats. Wait about a minute so the cotton can take up liquid, then draw gently. Nothing needs adjusting and there are no coils to prime by hand.
If the first pull tastes dry, give it another minute and try again with a shorter draw. A pod that has been stored cold benefits from a little extra settling time.
Battery, charging and the readout
A 950mAh cell sits in the body, charged through USB Type-C at 5V/1A. The screen reports the charge level, which removes the guesswork that comes with a sealed disposable. Expect 60 to 90 minutes for a full charge.
Top up at 20 to 30 percent rather than waiting for the device to die. Shallow charges keep the cell healthy and mean the body is never far from ready.
Who the device pod suits
Choose it if you already own the S3 body and want a specific flavour rather than a sampler. It also works well for anyone who likes a fruit or mint profile alongside a richer dessert pod, swapping between them through the day.
If you have no body yet, add the device to the order first. The pod is not a standalone vape.
Everyday care
Store pods upright with the cap on. Keep them out of sunlight and away from heaters. If condensation builds up in the body slot, wipe it with a dry tissue before fitting the next pod.
Do not leave the device charging overnight on bedding, and keep all nicotine products away from children and pets.
Local stock, fast dispatch
Pods ship from our Australian warehouse with no minimum order value. A single pod is enough to test a flavour, and larger orders are packed the same day when placed before cut-off.
Any fault on arrival is covered by our returns policy. Send the order number and a short description and we will sort it out. Full factory specifications are listed on the IGET official site.
Getting close to the rated puff count
The 10,000 figure assumes short, steady draws. Long pulls heat the mesh harder, use more liquid per puff and bring the end of the pod forward.
For example, a two second draw at a relaxed pace gets much closer to the rating than a five second pull. The same pod, used gently, simply lasts longer.
Signs the pod needs replacing
You will notice the change before any number tells you anything: the flavour thins out, the vapour feels warmer and a faint burnt edge appears after a rest.
At that point the coil is finished. Swap the pod, leave the body on charge and carry on with a fresh flavour.
Frequently asked questions
Does the device come with a pod?
No. The body is sold on its own so you can choose the flavour separately. Add one S3 pod, or an older BAR PLUS pod, to start vaping.
Is the device draw activated?
Yes. There is no fire button. The only controls are the charging port and the display.
How big is the device?
It measures Φ30.5 × 126.9 mm and weighs 100.6 g with a pod fitted, so it stands upright on a desk and fits a jacket pocket.
Which pods fit this body?
Both the 10,000 puff BAR PLUS S3 pod and the 6,000 puff BAR PLUS pod click into the same slot. Power delivery is managed automatically for either.
Can I use a fast charger?
A standard 5V/1A adapter is recommended. High-current fast chargers are not needed and add unnecessary heat.














Reviews
There are no reviews yet.